MacroAir Technologies WhisperFoil Manual de instalación

TM Installation Manual

Page 10 2.7 Universal Mounting Hardware We recommend mounting the fan to a horizontal structural beam, but this is not always possible in buildin

Page 11 Mounting Hardware Check all mounting bolts annually to be sure they have not loosened. Also, check the safety cable and guy wires to be s

Page 12 2 Installation Procedures Step 1, Install mounting hardware A) For glulam installations, attach the glulam brackets to the beam using

Page 13 Step 2, Attach Power Unit To Mounting Hardware A) B) C) We recommend using a scissor lift to install our fans. The best method is

B) C) D) Page 14 The MCP should be mounted at least 5 feet outside of the swept area of the fan blades; this will allow safe operation of

Page 15 Step 7, Make Motor Lead Connections A) B) C) D) Verify controller voltage; this can be found on the lower left corner of th

Page 16 E) Twist the three uninsulated stranded copper ground wires together (see figure 7) and connect them to the green ground screw located in

Page 17 Step 8, Install Guy Wires If an extension is installed, be sure to use the longer guy wires packaged with it. Be sure to use four guy wir

Page 18 1) Attach the tool to a 3/8 inch drive ratchet. 2) Loop the tool through the free end of the guy wire between the clamps and turn clo

Page 19 B) Install extended blade safety links . This step is REQUIRED — omitting it will void manufacturer's warranty! Fig 12

Page 2 Installation Manual Contents Anatomy of a Fan -------------------------------------------------------------------------------------------------

Page 20 Step 11, Install Guards If Necessary Refer to Section 2.6 on page 10 for guidelines. Step 12, Install Input Power A) B) C) V

Page 21 F) If the fan is turning the wrong way on initial startup, follow the procedure below: i) ii) iii) iv) v) vi) vii)

Page 22 3 Installation Procedures For eco6 Guard Fan Step 1, Install Mounting Assembly For Wall-Mounted Applications Fig 14 A) B

Page 23 For Pole-Mounted Applications Fig 15 A) Cut and mount bracketing. i) Cut and assemble UniStrut or equivalent bracketi

!

!

!

!

!

!

Page 3 2 Installation Procedures ----------------------------------------------------------------------------------------------------- 12 Step 1,

!

Page 4 Anatomy of a Fan MacroAir, Inc. www.macroairfans.com Toll Free: 866-668-3247 Buil

Page 5 Check Your Shipment, What's Included For 6 Blade Fans Note:Some models may vary slightly Blade Carton (Blades) Power Unit Carton Remote

Page 6 Check Your Shipment, What's Included For eco6 Guard Fan Motor Mount Assembly Motor/gearbox, Hybrid Hub, and keyless bushing adapter

Page 7 Please Read this Important Information Before you Install Fans • Make sure Power is OFF before beginning any installation or maintenance p

Page 8 1.5 Sprinkler Systems and Fan Placement In any installation where fire sprinklers are in place, do not interfere with their correct operat

Page 9 2.1 Weight A standard 1-horsepower 24 foot 6-blade fan weighs about 240 pounds, including the standard mounting hardware. In inverted-bla